Users Guide

3 Remove the disconnected interface (Te 0/1) from the conguration mode of PE 1 in System A. The conguration would be already
available in System A and needs to be removed.
PE CONFIGURATION (BATCH mode)
no cascade interface interface slot/port
Dell(conf-b-pe-1)# no cascade interface TenGigabitEthernet 0/1
4 Congure the cascade interface of the System B through the batch mode of System A and commit the conguration.
PE CONFIGURATION (BATCH mode)
cascade interface interface slot/port peer
Dell(conf-b-pe-1)# cascade interface TenGigabitEthernet 1/4 peer
Once the cascade interfaces are congured, the PE starts functioning in a dual homing setup as shown in the following diagram:
Figure 111. Standalone System and System with PE — After setting up Dual Homing
You can congure PE 1 from both System A and System B.
Port Extenders (PEs)
755