Administrator Guide

R 2.1.3.0/24 via 2.1.4.1, Te 2/43 120/1 3d1h
C 2.1.4.0/24 Direct, Te 2/43 0/0 3d1h
Related
Commands
ip prefix-list — enters CONFIGURATION-IP PREFIX-LIST mode and configures a prefix list.
show ip prefix-list summary — displays a summary of the configured prefix lists.
show ip route summary
View a table summarizing the IP routes in the switch.
C9000 Series
Syntax
show ip route summary
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.1.1.0 Introduced on the E-Series.
Usage Information The following describes the show ip route summary shown in the following example.
Column
Heading
Description
Route Source Identifies how the route is configured in the system.
Active Routes Identifies the best route if a route is learned from two protocol sources.
Non-active Routes Identifies the back-up routes when a route is learned by two different protocols. If the
best route or active route goes down, the non-active route becomes the best route.
ospf 100 If routing protocols (OSPF, RIP) are configured and routes are advertised, then
information on those routes is displayed.
Total 1388
active...
Displays the number of active and non-active routes and the memory usage of those
routes. If there are no routes configured in the system, this line does not appear.
Example
Dell>show ip route summary
Route Source Active Routes Non-active Routes
connected 17 0
static 3 0
ospf 100 1368 2
IPv4 Routing 895