Administrator Guide
Version Description
8.1.1.0 Introduced on the E-Series ExaScale.
7.5.1.0 Introduced on the C-Series.
pre-6.1.1.0 Introduced on the E-Series.
Usage Information When a static route (or a protocol route) overlaps with Management static route, the static route (or a protocol
route) is preferred over the Management Static route. Also, Management static routes and the Management
Connected prefix are not reflected in the hardware routing tables. Separate routing tables are maintained for IPv4
and IPv6 management routes. This command manages both tables.
Related
Commands
interface ManagementEthernet — configures the Management port on the system (either the Primary or
Standby RPM).
speed (Management interface) — sets the speed for the Management interface.
show arp
Display the ARP table entries learned on a switch CPU.
C9000 Series
Syntax
show arp [cpu [cp | rp]] [interface interface | ip ip-address [mask] |
macaddress mac-address mask] [static | dynamic] [summary]
Parameters
cpu cp (OPTIONAL) Enter the keywords cpu cp to display the ARP entries learned on the
Control Processor.
cpu rp (OPTIONAL) Enter the keyword cpu rp to display the ARP entries learned on the Route
Processor.
interface
interface
To specify an interface, enter one of the following interface types and slot/port or
number information:
• For Loopback interfaces, enter the keyword loopback then a number from zero (0)
to 16383.
• For a Port Channel interface, enter the keyword port-channel then a number. The
range is from 1 to 4096.
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then
the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/
port information.
• For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.
• For a tunnel interface, enter the keyword tunnel.
• For a port extender (PE) Gigabit Ethernet interface, enter the keyword peGigE then
the pe-id/ stack-unit unit number /port-ID information.
linecard
slot-id
(OPTIONAL) Enter the interface port-type slot/port parameters to display
the ARP entries learned on a Z9500 port. The range of slot IDs is from 0 to 2.
ip
ip-address mask
(OPTIONAL) Enter the keyword ip with an IP address in the dotted decimal format to
display the ARP entries learned with this IP address. Enter the optional IP address mask in
the slash prefix format (/ x).
macaddress
mac-
address mask
(OPTIONAL) Enter the keyword macaddress with a MAC address in nn:nn:nn:nn:nn:nn
format to display the ARP entries learned with this MAC address. Enter the optional MAC
address mask in nn:nn:nn:nn:nn format also.
static (OPTIONAL) Enter the keyword static to display manually-entered ARP entries.
dynamic (OPTIONAL) Enter the keyword dynamic to display dynamically-learned ARP entries.
IPv4 Routing 879