Administrator Guide

Version Description
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.2.1.0 Introduced on the E-Series.
Example
Dell(conf-if-po-1)# show config
!
interface Port-channel 1
no ip address
shutdown
Dell(conf-if-po-1)#
show interfaces port-channel
Display information on configured Port Channel groups.
C9000 Series
Syntax
show interfaces port-channel [channel-number] [brief]
Parameters
channel-number For a Port Channel interface, enter the keyword port-channel then a number. The
range is from 1 to 128.
brief (OPTIONAL) Enter the keyword brief to display only the port channel number, the
state of the port channel, and the number of interfaces in the port channel.
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the S-Series. Modified to display the LAG failover group status.
7.5.1.0 Introduced on the C-Series.
Usage Information
To view the show output for multiple ports of a specified slot at a time, you can specify any random port number
or a range of ports, or a combination of both.
To specify a port range, you can enter a hyphenated range of one or more port range values separated with
commas; for example, show interfaces port—channel 1-2,7. To enter any random number of ports,
you can enter a comma-separated string of port numbers, for example show interfaces port-channel
1,7
NOTE: The port-range option is only available for 1 Gigabit Ethernet, 10-Gigabit Ethernet, 40-
Gigabit Ethernet, Fast Ethernet, FC, Port Channel, and VLAN interfaces.
The following describes the show interfaces port-channel command shown in the following example.
748 Interfaces