Administrator Guide

Q Vlans
T 222
Name: Port-channel 111
802.1QTagged: True
Vlan membership:
Q Vlans
T 111
Example (port
range)
Dell#show interfaces switchport tengigabitethernet 10/0-1
Codes: U - Untagged, T - Tagged
x - Dot1x untagged, X - Dot1x tagged
G - GVRP tagged, M - Trunk
i - Internal untagged, I-Internal tagged, v-VLT untagged, V-VLT
tagged
Name: TenGigabitEthernet 10/0
802.1QTagged: False
Vlan membership:
Q Vlans
U 1
Name: TenGigabitEthernet 10/1
802.1QTagged: False
Vlan membership:
Q Vlans
U 1
Related
Commands
• interface — configures a physical interface on the switch.
• show ip interface — displays Layer 3 information about the interfaces.
• show interfaces — displays information on a specific physical interface or virtual interface.
• show interfaces transceiver — displays the physical status and operational status of an installed transceiver.
The output also displays the transceiver’s serial number.
show interfaces transceiver
Display the physical status and operational status of an installed transceiver. The output also displays the transceiver’s serial number.
C9000 Series
Syntax
show interfaces [tengigabitethernet slot/port | fortyGigE slot/port | peGigE
pe-id/stack-unit/port ] transceiver
Parameters
tengigabitetherne
t
For a 10G interface, enter the keyword tengigabitethernet then the slot/port
(ports or port range) information.
fortyGigE For a 40G interface, enter the keyword fortyGigE then the slot/port (ports or port-
range)information.
peGigE For a port extender Gigabit Ethernet interface, enter the keyword peGigE then the pe-
id / stack-unit / port-id information. The pe-id range is from 0 to 255; the stack-unit unit-
number range is from 0 to 7; and the port-id range is from 1 to 48.
NOTE: The peGigE option is only visible when the feature extended bridge
feature is enabled.
Command Modes
• EXEC
• EXEC Privilege
726 Interfaces