Administrator Guide

To disable optical power information updates, use the no enable optical-info-update interval
command.
Parameters
interval seconds Enter the keyword interval then the polling interval in seconds. The range is from 120
to 6000 seconds. The default is 300 seconds (5 minutes).
Defaults Disabled
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Replacement command for the S4820T. Replaces the enable xfp-power-updates
command.
8.3.11.4 Replacement command for the Z9000. Replaces the enable xfp-power-updates
command
8.3.10.0 Replacement command for the S4810 only. Replaces the enable xfp-power-
updates command.
Usage Information To enable polling and to configure the polling frequency, use this command.
end
Return to EXEC Privilege mode from other command modes (for example, CONFIGURATION or ROUTER OSPF modes).
C9000 Series
Syntax
end
Command Modes
• CONFIGURATION
• SPANNING TREE
• MULTIPLE SPANNING TREE
• LINE
• INTERFACE
• TRACE-LIST
• VRRP
• ACCESS-LIST
• PREFIX-LIST
• AS-PATH ACL
• COMMUNITY-LIST
• ROUTER OSPF
• ROUTER RIP
• ROUTER ISIS
• ROUTER BGP
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Control and Monitoring 71