Administrator Guide
Dell(conf-if-te-2/0)# no portmode hybrid
Dell(conf-if-vl-20)#
Related
Commands
• show interfaces switchport — displays the configuration of switchport (Layer 2) interfaces on the switch.
• switchport — places the interface in a Layer 2 mode.
• vlan-stack trunk — specifies an interface as a trunk port to the Stackable VLAN network.
rate-interval
Configure the traffic sampling interval on the selected interface.
C9000 Series
Syntax
rate-interval seconds
Parameters
seconds
Enter the number of seconds for which to collect traffic data. The range is from 5 to 299
seconds.
NOTE: Because polling occurs every 15 seconds, the number of seconds
designated here rounds to the multiple of 15 seconds lower than the entered
value. For example, if 44 seconds is designated, it rounds to 30; 45 to 59
seconds rounds to 45.
Defaults 299 seconds
Command Modes INTERFACE
Command History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.1.1.0 Introduced
Usage Information The output of the show interfaces command displays the configured rate interval, along with the collected
traffic data.
Related
Commands
show interfaces — displays information on physical and virtual interfaces.
rate-interval (Configuration Mode)
Configure the traffic sampling interval for all physical and logical port-channel interfaces globally. The support to configure rate-interval
globally enables you to modify the default interval rate for all physical and logical interfaces at one time.
Syntax
rate-interval seconds
Use the no rate-interval command to remove the sampling interval configuration.
Interfaces 695