Administrator Guide

Output packets: 1 0 pps
0
64B packets: 0 0 pps
0
Over 64B packets: 0 0 pps
0
Over 127B packets: 0 0 pps
0
Over 255B packets: 0 0 pps
0
Over 511B packets: 0 0 pps
0
Over 1023B packets: 0 0 pps
0
Error statistics:
00:04:36: %RPM0-P:CP %CHMGR-5-PEM_INSERTED: Power entry module 3 of unit 0
is inserted
Input underruns: 0 0 pps
0
Input giants: 0 0 pps
0
00:04:36: %RPM0-P:CP %CHMGR-0-PS_UP: Power supply 3 in unit 0 is up
Input throttles: 0 0 pps
0
Input CRC: 0 0 pps
0
Input IP checksum: 0 0 pps
0
Input overrun: 0 0 pps
0
Output underruns: 0 0 pps
0
Output throttles: 0 0 pps
0
m - Change mode c - Clear screen
l - Page up a - Page down
T - Increase refresh interval t - Decrease refresh
interval
q - Quit
mtu
Set the link maximum transmission unit (MTU) (frame size) for an Ethernet interface.
C9000 Series
Syntax
mtu value
To return to the default MTU value, use the no mtu command.
Parameters
value Enter a maximum frame size in bytes. The range is from 594 to 9216. The default is 1554.
Defaults 1554
Command Modes INTERFACE
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.10(0.0) Reduced the maximum size of the maximum transmission unit (MTU) to 9216 bytes.
9.9(0.0) Introduced on the C9010.
692 Interfaces