Administrator Guide

timers bgp
Allows you to adjust the BGP network timers for all neighbors.
C9000 Series
Syntax
timers bgp keepalive holdtimer
To return to the default values, use the no timers bgp command.
Parameters
keepalive Enter the time interval in seconds between which the software sends keepalive
messages. The range is 1 to 65535. The default is 60 seconds.
holdtimer Enter the time interval in seconds which the software waits since the last keepalive
message before declaring a BGP peer dead. The range is 3 to 65535. The default is 180
seconds.
Defaults
• keepalive = 60 seconds
• holdtimer = 180 seconds
Command Modes ROUTER BGP
Command History
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.2.1.0 Introduced on the E-Series ExaScale.
7.4.1.0 Introduced
Related
Commands
neighbor timers – adjusts BGP timers for a specific peer or peer group.
IPv6 MBGP Commands
Multiprotocol BGP (MBGP) is an enhanced BGP that enables the multicast routing policy throughout the internet and connecting
multicast topologies between BGP and autonomous systems (AS). MBGP is implemented as per IETF RFC 1858.
show ipv6 mbgproutes
Display the selected IPv6 MBGP route or a summary of all MBGP routes in the table.
C9000 Series
Syntax
show ipv6 mbgproutes ipv6-address prefix-length | summary
Parameters
ipv6-address
prefix-length
(OPTIONAL) Enter the IPv6 address in the x:x:x:x::x format then the prefix length in
the /x format. The range is from /0 to /128.
NOTE: The :: notation specifies successive hexadecimal fields of zeros.
summary Display a summary of RPF routes.
Command Modes EXEC
Command History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Border Gateway Protocol 469