Administrator Guide

ManualsBrandsDell ManualsAccess PlatformsC9010 Modular Chassis Switch

441

442

443

444

445

446

447

448

449

450

neighbor peer-group passive

Enable passive peering on a BGP peer group, that is, the peer group does not send an OPEN message, but responds to one.

C9000 Series

Syntax

neighbor peer-group-name peer-group passive

To delete a passive peer-group, use the no neighbor peer-group-name peer-group passive

command.

Parameters

peer-group-name

Enter a text string up to 16 characters long as the name of the peer group.

Defaults Not configured.

Command Modes ROUTER BGP

Command History

Version Description

9.9(0.0) Introduced on the C9010.

9.2(1.0) Introduced on the Z9500.

8.2.1.0 Introduced on the E-Series ExaScale.

7.4.1.0 Introduced

Usage Information After you configure a peer group as passive, you must assign it a subnet using the neighbor subnet

command.

Commands

neighbor subnet – assigns a subnet to a dynamically-configured BGP neighbor.

neighbor remote-as

Create and specify the remote peer to the BGP neighbor.

C9000 Series

Syntax

neighbor {ipv6-address | peer-group-name} remote-as number

To delete a remote AS entry, use the no neighbor {ipv6-address | peer-group-name} remote-

as number command.

Parameters

ipv6-address

Enter the IPv6 address in the x:x:x:x::x format.

NOTE: The :: notation specifies successive hexadecimal fields of zeros.

peer-group-name

Enter the name of the peer group to enter the remote AS into routing tables of all routers

within the peer group.

number

Enter a number of the AS. The range is 1 to 65535.