Administrator Guide

The following describes the show ip bgp damp command shown in the following example.
Field Description
Network Displays the network ID to which the route is dampened.
From Displays the IP address of the neighbor advertising the dampened route.
Reuse Displays the hour:minutes:seconds until the dampened route is available.
Path Lists all the ASs the dampened route passed through to reach the destination network.
Example
Dell#show ip bgp dampened-paths
BGP local RIB : Routes to be Added 0, Replaced 0, Withdrawn 0
BGP local router ID is 192.168.11.5
Status codes: s suppressed, S stale, d dampened, h history, * valid, > best
Path source: I - internal, a - aggregate, c - confed-external, r -
redistributed
n - network, D - denied, S - stale
Origin codes: i - IGP, e - EGP, ? - incomplete
Network From Reuse Path
d 55.0.0.0/24 172.16.0.2 00:36:23 200
Dell#
BGP Extended Communities (RFC 4360)
BGP Extended Communities, as defined in RFC 4360, is an optional transitive BGP attribute.
BGP Extended Communities provides two major advantages over Standard Communities:
• The range is extended from 4-octet (AA:NN) to 8-octet (Type:Value) to provide enough number communities.
• Communities are structured using a new “Type” field (1 or 2-octets), allowing you to provide granular control/filter routing information
based on the type of extended communities.
deny
To reject (deny) from the two types of extended communities, route origin (rt) or site-of-origin (soo), use this feature.
C9000 Series
Syntax
deny {rt | soo} {as4 ASN4:NN | ASN:NNNN | IPADDR:NN}
To remove (delete) the rule, use the no deny {rt | soo} {as4 ASN4:NN | ASN:NNNN |
IPADDR:NN} command.
Parameters
rt Enter the keyword rt to designate a Route Origin community.
soo Enter the keyword soo to designate a Site-of-Origin community (also known as Route
Origin).
as4 ASN4:NN Enter the keyword as4 then the 4-octet AS specific extended community number in the
format ASN4:NN (4-byte AS number:2-byte community value).
ASN:NNNN Enter the 2-octet AS specific extended community number in the format ASN:NNNN (2-
byte AS number:4-byte community value).
IPADDR:NN Enter the IP address specific extended community in the format IPADDR:NN (4-byte IPv4
Unicast Address:2-byte community value).
Defaults Not configured.
Command Modes CONFIGURATION (conf-ext-community-list)
Border Gateway Protocol 405