Administrator Guide

neighbor maximum-prefix
Control the number of network prefixes received.
C9000 Series
Syntax
neighbor {ip-address | peer-group-name} maximum-prefix maximum [threshold]
[warning-only]
To return to the default values, use the no neighbor {ip-address | peer-group-name} maximum-
prefix maximum command.
Parameters
ip-address Enter the IP address of the neighbor in dotted decimal format.
peer-group-name Enter the name of the peer group.
maximum Enter a number as the maximum number of prefixes allowed for this BGP router. The
range is from 1 to 4294967295.
threshold (OPTIONAL) Enter a number to be used as a percentage of the maximum value. When
the number of prefixes reaches this percentage of the maximum value, the E-Series
software sends a message. The range is from 1 to 100 percent. The default is 75.
warning-only (OPTIONAL) Enter the keyword warning-only to set the router to send a log
message when the maximum value is reached. If this parameter is not set, the router
stops peering when the maximum number of prefixes is reached.
Defaults threshold = 75
Command Modes ROUTER BGP
Command History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
Usage Information If you configure the neighbor maximum-prefix command and the neighbor receives more prefixes than the
neighbor maximum-prefix command configuration allows, the neighbor goes down and the show ip bgp
summary command displays (prfxd) in the State/PfxRcd column for that neighbor. The neighbor remains down
until you enter the clear ip bgp command for the neighbor or the peer group to which the neighbor belongs
or you enter the neighbor shutdown and neighbor no shutdown commands.
Related
Commands
show ip bgp summary — displays the current BGP configuration.
neighbor next-hop-self
Allows you to configure the router as the next hop for a BGP neighbor. (This command is used for IBGP).
C9000 Series
Syntax
neighbor {ipv6-address | peer-group-name} next-hop-self [all]
352 Border Gateway Protocol