Administrator Guide

out Enter the keyword out to filter outbound BGP routes.
Defaults Not configured.
Command Modes
• ROUTER BGP
• ROUTER BGP-address-family
Command History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.11.1 Introduced on the Z9000.
7.8.1.0 Introduced on the S-Series.
Increased the name string to accept up to 140 characters. Prior to 7.8.1.0, ACL names
were up to 16 characters long.
7.7.1.0 Introduced on the C-Series.
Usage Information To enter AS-PATH ACL mode and configure the AS-PATH filters to deny or permit BGP routes based on
information in their AS-PATH attribute, use the ip as-path access-list command in CONFIGURATION
mode.
Related
Commands
ip as-path access-list — enter AS-PATH ACL mode and configure the AS-PATH filters.
neighbor graceful-restart
Enable graceful restart on a BGP neighbor.
C9000 Series
Syntax
neighbor {ip-address | peer-group-name} graceful-restart [restart-time seconds]
[stale-path-time seconds] [role receiver-only]
To return to the default, enter the no bgp graceful-restart command.
Parameters
ip-address Enter the IP address of the neighbor in dotted decimal format.
peer-group-name Enter the name of the peer group to apply the filter to all routers in the peer group.
restart-time
seconds
Enter the keyword restart-time then the maximum number of seconds to restart and
bring-up all the peers. The range is from 1 to 3600 seconds. The default is 120 seconds.
stale-path-time
seconds
Enter the keyword stale-path-time then the maximum number of seconds to wait
before restarting a peer’s stale paths. The default is 360 seconds.
role receiver-only Enter the keyword role receiver-only to designate the local router to support
graceful restart as a receiver only.
Defaults as above
Command Modes ROUTER BGP
Command History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
350 Border Gateway Protocol