Administrator Guide
54:Task(tUsrRoot): [ 562]=========================================
55:Task(tUsrRoot): [ 51]sysDrvLoggerFreezeTop: Top of Log Frozen.
56:Task(tUsrRoot): [ 40]===== FREEZE BY REQUEST =================
57:Task(tUsrRoot): [ 39]=========================================
58:Task(tUsrRoot): [ 53]51:SS DRV DEBUG: bcmDrvInit Done
59:Task(tUsrRoot): [ 67]51:SS DRV DEBUG: bcmDrvInit: Returning, Time
taken 20131916 micro-secs
60:Task(ifagt_1): [ 3447148]SS DRV ERR: BCM API Invocation
Error(bcm_phy84740_pmad_reg_get failed
61:Task(ifagt_1): [ 1070425]SS DRV ERR: BCM API Invocation
Error(bcm_phy84740_pmad_reg_get failed (<- repeated 9 times)
62:Task(ifagt_1): [ 1070425]56:SS DRV DEBUG:
halOpticsUpdateSerialIdInfoUpdate: Update Serial ID Info for XFP48
63:Task(envmgr): [ 1561704]EEPROM LIB ERR: decipherPpId:371 Invalid ppId[]
size[0]
64:Task(ifagt_1): [ 3351519774]EEPROM LIB ERR: decipherPpId:371 Invalid
ppId[] size[0] (<- repeated 1 times)
65:Task(ifagt_1): [ 3351519774]SS DRV ERR: BCM API Invocation
Error(bcm_phy84740_pmad_reg_get failed
show logging kernellog
Display the kernel log for the specified hardware component.
C9000 Series
Syntax
show logging kernellog {cp | rp | linecard slot-id | pe pe-id stack unit unit-
number}
From a PE console, use show logging kernellog stack-unit unit number to display the kernel
logging information for a specified stack-unit.
Parameters
cp Enter the keyword cp to display the kernel log for the Control Processor on the switch.
rp Enter the keyword cp to display the kernel log for the Route Processor on the switch.
linecard
slot-id
Enter the linecard slot-id parameters to specify the line-card ports for which you
want to display the kernel log. The range of line-card slot IDs is from 0 to 2.
pe
pe-id
Enter the keyword pe and the port extender the ID to display the kernel log for the
specified port extender. The PE ID range is from 0 to 255.
stack unit
unit
number
Enter keyword stack-unit and the stack-unit number to display the kernel log for the
specified stack unit. Stack-unit number range is from 0 to 7.
defaults none
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.11(0.0) Introduced on N20xx and N30xx series.
9.9(0.0) Introduced on the C9010 and C1048P.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
1524 Simple Network Management Protocol (SNMP) and Syslog