Administrator Guide

undebug all
Disable all debug operations on the system.
C9000 Series
Syntax
undebug all
Defaults none
Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.11.1 Introduced on the Z9000.
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
E-Series Original command
upload trace-log
Upload a trace log file from a switch CPU.
C9000 Series
Syntax
upload trace-log {cp [cmd-history]| linecard | slot-id | pe pe-id [stack-unit
unit number ] |rp } [sw-trace | hw-trace]
Parameters
rp Enter the keyword rp to upload a trace log from the Route Processor.
cp Enter the keyword cp to upload a trace log from the Control Processor.
linecard slot-id Enter the linecard slot-id parameters to specify the line-card CPU whose trace
log you want to upload.
cmd-history Enter the keyword cmd-history to upload the command history from the specified
CPU.
hw-trace Enter the keyword hw-trace to upload the hardware trace log from the specified CPU.
sw-trace Enter the keyword sw-trace to upload the software trace log from the specified CPU.
pe pe-id Enter the keyword pe and port extender ID. Range is from 0 to 255.
NOTE: The pe option is only available when the extended bridge feature is
enabled.
stack unit number Enter the keyword stack unit and a stack unit number. Stack unit range is from 0 to
7.
Control and Monitoring 151