Administrator Guide

auth-password] [priv {des56 | aes128} priv password] [access access-list-name |
ipv6 access-list-name | access-list-name ipv6 access-list-name] command.
Parameters
name Enter the name of the user (not to exceed 20 characters), on the host that connects to
the agent.
group_name Enter a text string (up to 20 characters long) as the name of the group. The following
groups are created for mapping to read/write community/security-names (defaults):
• v1v2creadu — maps to a community with ro permissions.
• 1v2cwriteu — maps to a community rw permissions.
remote ip-address Enter the keywords udp-port then the user datagram protocol (UDP) port number on
the remote device. The range is from 0 to 65535. The default is 162.
udp-port port-
number
Enter the keywords udp-port then the UDP (User Datagram Protocol) port number on
the remote device. The range is from 0 to 65535. The default is 162.
1 | 2c | 3 (OPTIONAL) Enter the security model version number (1, 2c, or 3):
• 1 is the least secure version.
• 3 is the most secure of the security modes.
• 2c allows transmission of informs and counter 64, which allows for integers twice the
width of what is normally allowed.
The default is 1.
encrypted (OPTIONAL) Enter the keyword encrypted to specify the password appear in
encrypted format (a series of digits, masking the true characters of the string).
auth (OPTIONAL) Enter the keyword auth to specify authentication of a packet without
encryption.
md5 | sha (OPTIONAL) Enter the keyword md5 or sha to designate the authentication level.
• md5 — Message Digest Algorithm
• sha — Secure Hash Algorithm
auth-password (OPTIONAL) Enter a text string (up to 20 characters long) password that enables the
agent to receive packets from the host. Minimum: eight characters long.
priv (OPTIONAL) Enter the keywords priv to initiate a privacy authentication level setting.
des56 | aes128 (OPTIONAL) Enter the keyword des56 or aes128 to specify the encryption mode.
• aes128 — Use 128 bit AES algorithm in CFB mode for encryption.
• des56 — Use 56 bit DES algorithm in CBC mode for encryption.
priv password (OPTIONAL) Enter a text string (up to 20 characters long) password that enables the
host to encrypt the contents of the message it sends to the agent. Minimum: eight
characters long.
access access-
list-name
(Optional) Enter the standard IPv4 access list name (a string up to 16 characters long).
ipv6 access-list-
name
(Optional) Enter the keyword ipv6 then the IPv6 access list name (a string up to 16
characters long).
access-list-name
ipv6 access-list-
name
(Optional) Enter both an IPv4 and IPv6 access list name.
Defaults As above.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
1500 Simple Network Management Protocol (SNMP) and Syslog