Administrator Guide

threshold-value
Enter the power threshold limit value in percentage. Range is from 10 to 99%. Default
value is 99%.
Default None
Command Modes
CONFIGURATION
CONFIGURATION TERMINAL BATCH
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.10(0.0) Introduced the Configuration Terminal Batch mode on C9010.
9.9(0.0) Introduced on the C9010.
Usage Information
Configure a global threshold limit for the Power over Ethernet (PoE) power budget for a specified port extender.
A default power threshold value of 99% is configured when there is no threshold value configured.
Use this command in Configuration Terminal Batch mode to configure the threshold limit for the PoE power
budget in a dual-homing setup.
Example
Dell(conf)#power budget global-threshold pe 1 stack-unit 0 99
Dell#show power detail pe 0 stack-unit 0
Unit Total System Redundancy Inline Inline Inline Inline Inline
Power Power Power Power Power Power Power Power
Available Consumed Consumed Threshold Available Allocated Consumed
Remaining
(Watts) (Watts) (Watts) (%) (Watts) (Watts) (Watts) (Watts)
--------- ---------- --------- --------- --------- --------- ---------
--------------
0/0 1000 150 0 99 841 0 0 841
Related Command show power detail
power inline
Enable inline power and configure maximum power allocation with priority for the powered device connected to an interface.
C9000 Series
Syntax
power inline {[max_milliwatts ]| priority {critical | high | low}}
To disable a device that has been enabled for PoE power supply, use the no power inline command.
Parameters
max_milliwatts (OPTIONAL) Specify the maximum amount of inline power allocation to a powered device
connected to the interface. Range is 440–30000 milliwatts (mWs). The default value is
30000 mWs.
NOTE: The max_milliwatt configuration is effective only in Static mode.
priority Enter the keyword priority to specify the PoE priority for the powered device
connected to the interface. Default priority value is low.
critical Enter the keyword critical to set the PoE priority level as critical.
high Enter the keyword high to set the PoE priority level as high.
low Enter the keywordlow to set the PoE priority as low.
Defaults Default priority is low.
Port Extenders (PE) 1277