Administrator Guide

ManualsBrandsDell ManualsAccess PlatformsC9010 Modular Chassis Switch

1271

advertise dot3-tlv

Configure the system or an interface to advertise IEEE 802.3at extended power-via-mdi.

C9000 Series

Syntax

advertise dot3-tlv power-via-mdi

To remove the advertised dot3–tlv, use the no advertise dot3–tlv power-via-mdi command

Parameters

power-via-mdi Enter the keyword power—via-mdi to advertise IEEE 802.3at power-via-mdi TLV.

Defaults Disabled

Command Modes

• LLDP CONFIGURATION (conf-lldp)

• INTERFACE LLDP CONFIGURATION (conf-if-interface-lldp)

Command History

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell

Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version Description

9.9(0.0) Introduced on the C9010.

Usage Information

The advertise dot3–tlv power—via—mdi command enables the system to advertise IEEE 802.3at

power-via-mdi TLV to advertise its power negotiation capabilities with the powered devices via Link Layer

Discovery Protocol (LLDP). You can configure this command either on a specific interface or globally.

Example

Dell(conf)#interface peGigE 0/0/0

Dell(conf-if-pegi-0/0/0)#protocol lldp

Dell(conf-if-pegi-0/0/0-lldp)#advertise dot3-tlv power-via-mdi

Dell(conf-if-pegi-0/0/0-lldp)#

advertise med power-via-mdi

Configure the system to advertise IEEE 802.1ab extended power-via— MDI TLV.