Administrator Guide

DELL(conf-pe-0)# cascade interface TenGigabitEthernet 0/14-15
DELL(conf-pe-0)# description Test
DELL(conf-pe-0)# stack-unit 0 description first
DELL(conf-pe-0)# stack-unit 1 description second
Related
Commands
• feature extended-bridge
• stack unit
• show pe
show config
Display the PE provision configuration details.
C9000 Series
Syntax
show config
Command Modes PE CONFIG (conf-pe-pe-id)
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
Example
Dell(conf-pe-5)# show config
!
pe provision 5
stack-unit 4 type C1048P
Dell(conf)#pe 255
Dell(conf-pe-255)#show config
!
pe provision 255
cascade interface TenGigabitEthernet 6/0
stack-unit 1 type C1048P
show ecid
Display the E-Channel identifier (ECID) information for all or any specified interfaces.
C9000 Series
Syntax
show ecid {interface [interface] | pe pe-id stack—unit unit-number}
Parameters
interface interface
Enter the interface keyword, and specify one of the following interface types:
• For a PE Gigabit Ethernet interface, enter the keyword peGigE. You must specify a
pe-id/stack-unit/port-id for the interface.
• For a port channel interface, enter the keyword port-channel
• For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.
.
1252 Port Extenders (PE)