Administrator Guide

Example (Brief)
Dell#show track ipv6 route brief
ResId Resource Parameter State LastChange
2 IPv6 route metric threshold 2040::/64 Up 00:02:36
3 IPv6 route reachability 2050::/64 Up 00:02:36
Related
Commands
• show running-config track – displays configuration information about tracked objects.
• show track – displays information about tracked objects, including configuration, current state, and clients
which track the object.
• track interface ipv6 routing – configures object tracking on the routing status of an IPv6 Layer 3 interface.
• track ipv6 route metric threshold – configures object tracking on the threshold of an IPv6 route metric.
• track ipv6 route reachability – configures object tracking on the reachability of an IPv6 route.
track interface ipv6 routing
Configure object tracking on the routing status of an IPv6 Layer 3 interface.
C9000 Series
Syntax
track object-id interface interface ipv6 routing
To return to the default setting, use the no track object-id command.
Parameters
object-id Enter the ID number of the tracked object. The range is from 1 to 500.
interface Enter one of the following values:
• For a 1-Gigabit Ethernet interface, enter the keyword GigabitEthernet then the
slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then
the slot/port
• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/
port information.
• For a Loopback interface, enter the keyword loopback then a number from 0 to
16383.
• For a port channel interface, enter the keywords port-channel then a number.
• For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.
Defaults none
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000-ON.
8.3.12.0 Introduced on the S4810.
8.4.1.0 Introduced.
Usage Information Use this command to create an object that tracks the routing state of an IPv6 Layer 3 interface:
• The status of the IPv6 interface is UP only if the Layer 2 status of the interface is UP and the interface has a
valid IP address.
Object Tracking 1073