Administrator Guide

set metric {+ | - | metric-value}
● Specify an OSPF or ISIS type for redistributed routes.
CONFIG-ROUTE-MAP mode
set metric-type {external | internal | type-1 | type-2}
● Assign an IP address as the route’s next hop.
CONFIG-ROUTE-MAP mode
set next-hop ip-address
● Assign an IPv6 address as the route’s next hop.
CONFIG-ROUTE-MAP mode
set ipv6 next-hop ip-address
● Assign an ORIGIN attribute.
CONFIG-ROUTE-MAP mode
set origin {egp | igp | incomplete}
● Specify a tag for the redistributed routes.
CONFIG-ROUTE-MAP mode
set tag tag-value
● Specify a value as the route’s weight.
CONFIG-ROUTE-MAP mode
set weight value
To create route map instances, use these commands. There is no limit to the number of set commands per route map, but the
convention is to keep the number of set filters in a route map low. Set commands do not require a corresponding match
command.
Configure a Route Map for Route Redistribution
Route maps on their own cannot affect traffic and must be included in different commands to affect routing traffic.
Route redistribution occurs when the system learns the advertising routes from static or directly connected routes or another
routing protocol. Different protocols assign different values to redistributed routes to identify either the routes and their origins.
The metric value is the most common attribute that is changed to properly redistribute other routes into a routing protocol.
Other attributes that can be changed include the metric type (for example, external and internal route types in OSPF) and route
tag. Use the redistribute command in OSPF, RIP, ISIS, and BGP to set some of these attributes for routes that are
redistributed into those protocols.
Route maps add to that redistribution capability by allowing you to match specific routes and set or change more attributes
when redistributing those routes.
In the following example, the redistribute command calls the route map static ospf to redistribute only certain static
routes into OSPF. According to the route map static ospf, only routes that have a next hop of Tengigabitethernet interface
0/0 and that have a metric of 255 are redistributed into the OSPF backbone area.
NOTE:
When re-distributing routes using route-maps, you must create the route-map defined in the redistribute
command under the routing protocol. If you do not create a route-map, NO routes are redistributed.
Example of Calling a Route Map to Redistribute Specified Routes
router ospf 34
default-information originate metric-type 1
redistribute static metric 20 metric-type 2 tag 0 route-map staticospf
!
route-map staticospf permit 10
match interface TengigabitEthernet 0/0
match metric 255
set level backbone
Access Control Lists (ACLs)
133