Users Guide

IPv6 hop limit for originated packets is 64
ND dns-server address is 1000::1 with lifetime of 1 seconds
ND dns-server address is 3000::1 with lifetime of 1 seconds
ND dns-server address is 2000::1 with lifetime of 0 seconds
IP unicast RPF check is not supported
To display IPv6 RDNSS information, use the show configuration command in INTERFACE CONFIG mode.
Dell(conf-if-te-1/1)#show configuration
The following example uses the show configuration command to display IPv6 RDNSS information.
!
interface TenGigabitEthernet 1/1
no ip address
ipv6 address 1212::12/64
ipv6 nd dns-server 1000::1 1
ipv6 nd dns-server 3000::1 1
ipv6 nd dns-server 2000::1 0
no shutdown
Secure Shell (SSH) Over an IPv6 Transport
Both inbound and outbound secure shell (SSH) sessions using IPv6 addressing are supported.
Inbound SSH supports accessing the system through the management interface as well as through a physical Layer 3 interface.
For SSH configuration details, refer to the Security chapter in the Dell Networking OS Command Line Interface Reference Guide.
Configuration Tasks for IPv6
The following are configuration tasks for the IPv6 protocol.
• Adjusting Your CAM-Profile
• Assigning an IPv6 Address to an Interface
• Assigning a Static IPv6 Route
• Configuring Telnet with IPv6
• SNMP over IPv6
• Showing IPv6 Information
• Clearing IPv6 Routes
Adjusting Your CAM Profile
Although adjusting your CAM profile is not a mandatory step, if you plan to implement IPv6 ACLs, Dell Networking recommends that you
adjust your CAM settings.
The CAM space is allotted in FP blocks. The total space allocated must equal 13 FP blocks. There are 16 FP blocks, but the System Flow
requires three blocks that cannot be reallocated.
You must enter the ipv6acl allocation as a factor of 2 (2, 4, 6, 8, 10). All other profile allocations can use either even or odd-numbered
ranges.
The default option sets the CAM Profile as follows:
• L3 ACL (ipv4acl): 6
• L2 ACL(l2acl): 5
• IPv6 L3 ACL (ipv6acl): 0
• L3 QoS (ipv4qos): 1
494
IPv6 Routing