Users Guide

• Enter up to 63 characters to configure one domain name.
CONFIGURATION mode
ip domain-name name
• Enter up to 63 characters to configure names to complete unqualified host names.
CONFIGURATION mode
ip domain-list name
Configure this command up to six times to specify a list of possible domain names. The system searches the domain names in the order
they were configured until a match is found or the list is exhausted.
Configuring DNS with Traceroute
To configure your switch to perform DNS with traceroute, use the following commands.
• Enable dynamic resolution of host names.
CONFIGURATION mode
ip domain-lookup
• Specify up to six name servers.
CONFIGURATION mode
ip name-server ip-address [ip-address2 ... ip-address6]
The order you entered the servers determines the order of their use.
• When you enter the traceroute command without specifying an IP address (Extended Traceroute), you are prompted for a
target and source IP address, timeout in seconds (default is 5), a probe count (default is 3), minimum TTL (default is 1), maximum TTL
(default is 30), and port number (default is 33434).
CONFIGURATION mode
traceroute [host | ip-address]
To keep the default setting for these parameters, press the ENTER key.
Example of the traceroute Command
The following text is example output of DNS using the traceroute command.
Dell#traceroute www.force10networks.com
Translating "www.force10networks.com"...domain server (10.11.0.1) [OK]
Type Ctrl-C to abort.
----------------------------------------------------------------------
Tracing the route to www.force10networks.com (10.11.84.18), 30 hops max, 40 byte packets
----------------------------------------------------------------------
TTL Hostname Probe1 Probe2 Probe3
1 10.11.199.190 001.000 ms 001.000 ms 002.000 ms
2 gwegress-sjc-02.force10networks.com (10.11.30.126) 005.000 ms 001.000 ms 001.000 ms
3 fw-sjc-01.force10networks.com (10.11.127.254) 000.000 ms 000.000 ms 000.000 ms
4 www.dell.com (10.11.84.18) 000.000 ms 000.000 ms 000.000 ms
Dell#
476
IPv4 Routing