Users Guide

Sample Configurations
Before you set up VRRP, review the following sample configurations.
VRRP for an IPv4 Configuration
The following configuration shows how to enable IPv4 VRRP. This example does not contain comprehensive directions and is intended to
provide guidance for only a typical VRRP configuration. You can copy and paste from the example to your CLI. To support your own IP
addresses, interfaces, names, and so on, be sure that you make the necessary changes. The VRRP topology was created using the CLI
configuration shown in the following example.
Figure 156. VRRP for IPv4 Topology
Example of Configuring VRRP for IPv4 Router 2
R2(conf)#int te 2/31
R2(conf-if-te-2/31)#ip address 10.1.1.1/24
Virtual Router Redundancy Protocol (VRRP)
1091