Administrator Guide

Parameters
slot-id Displays the cam entries for the mentioned linecard id.
port-set Enter the keyword port-set and specify the port-set number. The port-set
number value is 0.
vrf vrf-name (OPTIONAL) Enter the keyword vrf followed and the name of the VRF to display
IPv6 CAM entries corresponding to that VRF.
NOTE: If you do not specify this option, IPv6 CAM entries corresponding to
the default VRF are displayed.
X:X:X:X::X (OPTIONAL) Enter the network address or host name.
summary (OPTIONAL) Enter the keyword summary to display a table listing network prefixes
and the total number prefixes which can be entered into the IPv6 CAM.
Defaults none
Command Modes EXEC
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
9.0.0.0 Introduced on the Z9000.
8.3.19.0 Introduced on the S4820T.
8.3.7.1 Introduced on the S4810.
8.4.2.1 Introduced on the S-Series.
Example
Dell#show ipv6 cam linecard 10 port-set 0
Neighbor Mac-Addr Port VId EC
---------------------------------------------------------------
fe80::2ff:eff:fe3f:a1 00:00:00:00:00:00 CP 0 0
2::3 00:00:00:00:00:00 CP 0 0
refix Mac-Addr Port VId EC
---------------------------------------------------------------
2::/64 00:00:00:00:00:00 CP 0 0
fe80::/10 00:00:00:00:00:00 NuP 0 0
::/0 00:00:00:00:00:00 CP 0
show ipv6 control-plane icmp
Displays the status of the icmp control-plane setting for the error eate limit setting.
C9000 Series
Syntax
show ipv6 control-plane icmp
Default 100
Command Modes EXEC
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
IPv6 Basics 991