Administrator Guide

● For a Loopback interface, enter the keyword Loopback then a number from 0
to 16383.
● For the Management interface, enter the keyword ManagementEthernet
then zero (0).
● For the Null interface, enter the keyword null then zero (0).
● For a Port Channel interface, enter the keywords port-channel then a
number. The range is from 1 to 128.
● For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
● For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the
slot/port information.
● For a tunnel interface, enter the keyword tunnel then the tunnel interface
number. The range is from 1 to 16383.
● For a VLAN, enter the keyword vlan then a number from 1 to 4094.
linecard slot-id Enter the linecard slot-id parameters to specify the switch ports on a line
card. The range of slot IDs is from 0 to 2.
brief (OPTIONAL) Enter the keyword brief to view a brief summary of the interfaces
and whether an IP address is assigned.
configured (OPTIONAL) Enter the keyword configured to display the physical interfaces
with non-default configurations only.
Command Modes
● EXEC
● EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.11(0.0) Updated the command output to include the unicast reverse path forwarding
(uRPF) status.
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
8.3.7.0 Introduced on the S4810.
8.1.1.2 Supported on the E-Series ExaScale E600i.
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.1.1.0 Introduced on the E-Series.
Usage
Information
The following describes the show ip interface command shown in the following example.
Lines Description
TenGigabitEther
net 0/0...
Displays the interface’s type, slot/port, and physical and line protocol status.
Internet
address...
States whether an IP address is assigned to the interface. If an IP address is
assigned, that address is displayed.
IPv4 Routing 939