Administrator Guide

match community — redistributes routes that match the COMMUNITY attribute.
]neighbor send-community — assigns the COMMUNITY attribute.
show ip bgp community — displays BGP community groups.
show ip community-lists — displays configured Community access lists.
set level
To specify the IS-IS level or OSPF area to which matched routes are redistributed, configure a filter.
C9000 Series
Syntax
set level {backbone | level-1 | level-1-2 | level-2 | stub-area}
To remove a set level condition, use the no set level {backbone | level-1 | level-1-2 |
level-2 | stub-area} command.
Parameters
backbone Enter the keyword backbone to redistribute matched routes to the OSPF
backbone area (area 0.0.0.0).
level-1 Enter the keyword level-1 to redistribute matched routes to IS-IS Level 1.
level-1-2 Enter the keyword level-1-2 to redistribute matched routes to IS-IS Level 1 and
Level 2.
level-2 Enter the keyword level-2 to redistribute matched routes to IS-IS Level 2.
stub-area Enter the keyword stub to redistributed matched routes to OSPF stub areas.
Defaults Not configured.
Command Modes ROUTE-MAP
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.1.1.0 Introduced on the E-Series.
Related
Commands
set automatic-tag — computes the tag value of the route.
set metric — specifies the metric value assigned to redistributed routes.
set metric-type — specifies the metric type assigned to redistributed routes.
set tag — specifies the tag assigned to redistributed routes.
Access Control Lists (ACL) 299