Administrator Guide

stack-unit 5 N/A N/
A
stack-unit 6 N/A N/
A
stack-unit 7 N/A N/A
show rpm
View the current status of the RPM.
C9000 Series
Syntax
show rpm [slot-id [brief] | all]
Parameters
slot-id (OPTIONAL) Enter the RPM slot-ID zero (0) or 1.
all (OPTIONAL) Enter the keyword all to view a table with information on all present
RPMs.
brief (OPTIONAL) Enter the keyword brief to view an abbreviated list of RPM
information.
Command Modes
● EXEC
● EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
8.1.1.0 Introduced on the E-Series ExaScale.
7.5.1.0 Introduced on the C-Series.
E-Series Original command.
Usage
Information
Field Description
Status Displays the RPM’s status.
Next Boot Displays whether the RPM is to be brought online at the next system reload.
Card Type Displays the RPM catalog number.
Hardware Rev Displays the hardware revision level.
Num Ports Displays the number of active ports.
Up Time Displays the number of hours and minutes since the RPM’s last reboot.
Last Restart States the reason for the last RPM reboot.
Dell Networking
OS Version
Displays the operating software version.
Jumbo Capable Displays a Yes or No indicating if the RPM is capable of sending and receiving
Jumbo frames.
This field does not indicate if the chassis is in Jumbo mode; for that determination,
use the show chassis brief command.
134 Control and Monitoring