Administrator Guide

advertise management-tlv (Interface)
Advertise management type, length, values (TLVs) to the specified interface.
C9000 Series
Syntax
advertise management-tlv {management-address | system-capabilities |
system-description | system-name}
To remove advertised management TLVs, use the no advertise management-tlv
{management-address | system-capabilities | system-description | system-
name} command.
Parameters
management-
address
Enter the keywords management-address to advertise the management IP
address TLVs to the specified interface.
system-
capabilities
Enter the keywords system-capabilities to advertise the system capabilities
TLVs to the specified interface.
system-
description
Enter the keywords system-description to advertise the system description
TLVs to the specified interface.
system-name Enter the keywords system-name to advertise the system name TLVs to the
specified interface.
Defaults none
Command Modes INTERFACE (conf-interface-lldp)
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
9.1.(0.0) Introduced on the Z9000 and S4810.
8.3.19.0 Introduced on the S4820T.
clear lldp counters
Clear LLDP transmitting and receiving counters for all physical interfaces or a specific physical interface.
C9000 Series
Syntax
clear lldp counters interface
Parameters
interface Enter the following keywords and slot/port or number information:
● For a Gigabit Ethernet interface, enter the keyword GigabitEthernet then
the slot/port information.
● For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the
slot/port information.
● For a Management Ethernet interface, enter the keyword
managementethernet then the slot/port information.
● For a 10-Gigabit Ethernet interface, enter the keyword
tenGigabitEthernet then the slot/port information.
Link Layer Discovery Protocol (LLDP) 1053