Users Guide

Verifying System Images on C9010
Components
Each C9010 RPM contains three components: Control Processor (CP), Route Processor (RP), and line-card
processor (LP). Each RPM component has a separate system image stored in the A: and B: flash partitions. In
addition, each installed C9010 line card has a separate image stored in partitions A: and B:.
To display the system images currently stored for all C9010 components, enter the show boot system all
command. In the command output:
• Column A: lists the system images stored in flash partition A: for each RPM component. Column B: lists
the system images stored in partition B:.
• The components of RPM0 installed in chassis slot 10 are:
• RPM0 control processor: rmp 0 (CP)
• RPM0 route processor: rmp 0 (RP)
• RPM0 line-card processor: linecard 10
• The components of RPM1 installed in chassis slot 11 are:
• RPM1 control processor: rmp 1 (CP)
• RPM1 route processor: rmp 1 (RP)
• RPM1 line-card processor: linecard 11
• The rows linecard 0 through linecard 9 list the system images for each line card installed in
chassis slots 0 to 9.
Dell#show boot system all
Current system image information in the system:
===============================================
Type Boot Type A: B:
----------------------------------------------------------------
rpm 0 (CP) FLASH BOOT 1-0(0-4243)[boot] 1-0(0-4226)
rpm 1 (CP) FLASH BOOT 1-0(0-4243)[boot] 1-0(0-4226)
rpm 0 (RP) FLASH BOOT 1-0(0-4243)[boot] 1-0(0-4226)
rpm 1 (RP) FLASH BOOT 1-0(0-4243)[boot] 1-0(0-4226)
linecard 0 FLASH BOOT 1-0(0-4243)[boot] 1-0(0-4226)
linecard 1 FLASH BOOT 1-0(0-4243)[boot] 1-0(0-4226)
linecard 2 FLASH BOOT 1-0(0-4243)[boot] 1-0(0-4226)
linecard 3 is not present.
linecard 4 is not present.
linecard 5 is not present.
linecard 6 is not present.
linecard 7 is not present.
linecard 8 is not present.
linecard 9 is not present.
linecard 10 FLASH BOOT 1-0(0-4243)[boot] 1-0(0-4226)
linecard 11 FLASH BOOT 1-0(0-4243)[boot] 1-0(0-4226)
When System Images on C9010 Components
Do Not Match
You normally upgrade system images on all installed components at the same time by entering the upgrade
system-image all
command; for example: upgrade system-image all flash://FTOS-
Switch Management 93