Users Guide

BOOT_USER mode
BOOT_USER# boot change secondary
BOOT_USER# boot change default
5 Reboot the chassis.
BOOT_USER mode
reload
Restoring Factory-Default Settings
When you restore factory-default settings on a switch, the existing NVRAM settings, startup configuration, and
all configured settings are deleted.
To restore the factory-default settings, enter the restore factory-defaults {chassis | domain |
linecard | pe | rpm }
command in EXEC Privilege mode.
CAUTION: There is no undo for this command.
Important Point to Remember
• After the restore is complete, a switch reloads immediately.
The following example shows how the restore factory-defaults command restores a switch to its factory
default settings.
Dell# restore factory-defaults chassis nvram
***********************************************************************
* Warning - Restoring factory defaults will delete the existing *
* persistent settings (stacking, fanout, etc.) *
* After restoration the unit(s) will be powercycled immediately. *
* Proceed with caution ! *
***********************************************************************
Proceed with factory settings? Confirm [yes/no]:yes
-- Restore status --
Unit Nvram Config
------------------------
0 Success
Power-cycling the unit(s).
....
Switch Management 89