Users Guide

Dell(conf-if-vl-10)#tagged te 0/0
Dell(conf-if-vl-10)#exit
Dell(conf)#inte vlan 20
Dell(conf-if-vl-20)#mode remote-port-mirroring
Dell(conf-if-vl-20)#tagged te 0/1
Dell(conf-if-vl-20)#exit
Dell(conf)#interface vlan 30
Dell(conf-if-vl-30)#mode remote-port-mirroring
Dell(conf-if-vl-30)#tagged te 0/2
Dell(conf-if-vl-30)#exit
Dell(conf)#monitor session 1 type rpm
Dell(conf-mon-sess-1)#source remote-vlan 10 dest te 0/3
Dell(conf-mon-sess-1)#exit
Dell(conf)#monitor session 2 type rpm
Dell(conf-mon-sess-2)#source remote-vlan 20 destination te 0/4
Dell(conf-mon-sess-2)#tagged destination te 0/4
Dell(conf-mon-sess-2)#exit
Dell(conf)#monitor session 3 type rpm
Dell(conf-mon-sess-3)#source remote-vlan 30 destination te 0/5
Dell(conf-mon-sess-3)#tagged destination te 0/5
Dell(conf-mon-sess-3)#end
Dell#
Dell#show monitor session
SessID Source Destination Dir Mode Source IP Dest IP
------ ------ ----------- --- ---- --------- --------
1 remote-vlan 10 Te 0/3 N/A N/A N/A N/A
2 remote-vlan 20 Te 0/4 N/A N/A N/A N/A
3 remote-vlan 30 Te 0/5 N/A N/A N/A N/A
Dell#
Configuring RPM Source Sessions to Avoid BPD Issues
When you configure an RPM source session, you can avoid BPDU issues by using the configuration:
1 Enable the MAC control-plane egress ACL.
mac control-plane egress-acl
2 Create an extended MAC access list and add a deny rule for (0x0180c2xxxxxx) packets using the
following commands:
mac access-list extended mac2
seq 5 deny any 01:80:c2:00:00:00 00:00:00:ff:ff:ff count
3 Apply the extended MAC ACL on the RPM VLAN (VLAN 10 in the following example).
Dell#show running-config interface vlan 10
!
interface Vlan 10
no ip address
mode remote-port-mirroring
tagged Port-channel 2
mac access-group mac2 out
no shutdown
4 Create an RPM session (In the following example, port-channels 1 and 2 are LACP).
Dell(conf)#monitor session 1 type rpm
Dell(conf-mon-sess-1)#source port-channel 1 destination remote-vlan 10 dir
Port Monitoring 868