Users Guide

DATA=0x0000000000000000000000000000000000000000000000000000222222222222
MASK=0x0000000000000000000000000000000000000000000000000000222222222223
DstMac
Offset: 88 Width: 48
DATA=0x00000180 c2000021
MASK=0x0000ffff ffffffff
action={act=DropPrecedence, param0=1(0x1), param1=0(0), param2=0(0),
param3=0(0)}
action={act=Drop, param0=0(0), param1=0(0), param2=0(0), param3=0(0)}
action={act=CosQCpuNew, param0=4(0x4), param1=0(0), param2=0(0),
param3=0(0)}
action={act=CopyToCpu, param0=1(0x1), param1=5(0x5), param2=0(0),
param3=0(0)}
policer=
statistics={stat id 8 slice = 9 idx=2 entries=1}{Packets}
Viewing Per-Protocol CoPP Counters
To view per-protocol counters of rate-limited control-plane traffic, use the show control-traffic
protocol [cp-switch | [linecard {0-11} portset {0-0}] | [port-extender {0-255}
stack-unit {0-7} portset {0-0}] counters command, where:
• cp-switch displays counters for rate-limited traffic on the central switch (aggregated CoPP).
• linecard portset displays counters for rate-limited traffic on a specified switch line card and port set
(distributed CoPP).
In the show output, Rx Counters displays the number of bytes of control-plane traffic received, on which
protocol-based rate limiting is applied. Tx Counters displays the number of bytes transmitted to a control-
plane CPU after protocol-based rate limiting is applied. Drop Counters displays the number of bytes of
control-plane traffic that have been dropped as a result of protocol-based rate limiting.
Dell# show control-traffic protocol linecard 2 portset 0 counters |no-more
Protocol RxBytes TxBytes Drops
------- ------- ------- -----
STP 0 0 0
LLDP 8659 8659 0
PVST 0 0 0
LACP 0 0 0
GVRP 0 0 0
ARP RESP/ARP REQ 0 0 0
802.1x 0 0 0
FEFD 0 0 0
FRRP 0 0 0
ECFM 0 0 0
L2PT 0 0 0
ISIS 0 0 0
BFD 0 0 0
BGP 0 0 0
v6 BGP 0 0 0
OSPF 0 0 0
v6 OSPF/RIP 0 0 0
VRRP 0 0 0
v6 VRRP 0 0 0
IGMP 0 0 0
PIM 0 0 0
NTP 0 0 0
MULTICAST CATCH ALL/v6 MULTICAST CATCH ALL 0 0 0
v6 ICMP RS 0 0 0
DHCP RELAY/DHCP/IPv6 DHCP 0 0 0
Control Plane Policing (CoPP) 284