Users Guide

back-up destination {ip address ipv4-address/mask | ipv6 address ipv6-address/
mask}
Dell(conf-vlt-domain)#back-up destination ?
A.B.C.D IP address for VLT backup link
ipv6 Configure IPv6 address for VLT backup link
IPv4 address (A.B.C.D) or IPv6 address (X:X:X:X::X) of the VLT peer’s management interface.
5 Repeat Steps 1 – 4 on the VLT peer switch.
To set the amount of time, in seconds, to delay the system from restoring the VLT port, use the delay-
restore command at any time. For more information, refer to VLT Port Delayed Restoration.
Configuring a VLT Port Delay Period
To configure a VLT port delay period, use the following commands.
1 Enter VLT-domain configuration mode for a specified VLT domain.
CONFIGURATION mode
vlt domain domain-id
The range of domain IDs from 1 to 1000.
2 Enter an amount of time, in seconds, to delay the restoration of the VLT ports after the system is
rebooted.
CONFIGURATION mode
delay-restore delay-restore-time
The range is from 1 to 1200.
The default is 90 seconds.
Reconfiguring the Default VLT Settings
(Optional)
To reconfigure the default VLT settings, use the following commands.
1 Enter VLT-domain configuration mode for a specified VLT domain.
CONFIGURATION mode
vlt domain domain-id
The range of domain IDs is from 1 to 1000.
2 (Optional) When you create a VLT domain on a switch, the system automatically creates a VLT-system
MAC address used for internal system operations.
VLT DOMAIN CONFIGURATION mode
Virtual Link Trunking (VLT) 1184