Administrator Guide

Version Description
9.10(0.0) Introduced the Configuration Terminal Batch mode on C9010.
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.7.0 Introduced on the S4810.
8.4.2.1 Introduced on the S-Series.
8.2.1.0 Introduced on the E-Series ExaScale.
7.8.1.0 Introduced on the C-Series. Increased the name string to accept up to 140 characters.
Prior to version 7.8.1.0, names are up to 16 characters long.
7.4.1.0 Introduced on the E-Series TeraScale.
Usage Information
The number of entries allowed per ACL is hardware-dependent. For detailed specification on entries allowed per
ACL, refer to your line card documentation.
Use this command in Configuration Terminal Batch mode to configure the access list in a dual-homing setup.
Related
Commands
show config — views the current configuration.
ipv6 control-plane egress-filter
Enable egress Layer 3 ACL lookup for IPv6 CPU traffic.
C9000 Series
Syntax
ipv6 control-plane egress-filter
Defaults Not enabled.
Command Modes
EXEC Privilege
CONFIGURATION TERMINAL BATCH
Command History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.10(0.0) Introduced the Configuration Terminal Batch mode on C9010.
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
9.0.0.0 Introduced on the Z9000.
8.3.19.0 Introduced on the S4820T.
8.3.10.0 Introduced on the S4810.
IPv6 Access Control Lists (IPv6 ACLs) 923