Administrator Guide
rp (OPTIONAL) Enter the keyword rp to view only IP traffic statistics from the Route
Processor.
Default View IP traffic statistics from all processors.
Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.1.1.0 Introduced on the E-Series.
Usage Information The following describes the show ip traffic summary shown in the following example.
Keyword Definition
unknown
protocol...
No receiver for these packets. Counts packets whose protocol type field is not
recognized by the system.
not a gateway... Packets can not be routed; the host/network is unreachable.
security failures... Counts the number of received unicast/multicast packets that could not be forwarded
due to:
• route not found for unicast/multicast; ingress interfaces do not belong to the
destination multicast group
• destination IP address belongs to reserved prefixes; the host/network is unreachable
bad options... Unrecognized IP option on a received packet.
Frags: IP fragments received.
... reassembled Number of IP fragments that were reassembled.
... timeouts Number of times a timer expired on a reassembled queue.
... too big Number of invalid IP fragments received.
... couldn’t
fragment
Number of packets that could not be fragmented and forwarded.
...encapsulation
failed
Counts packets which could not be forwarded due to ARP resolution failure. The system
sends an ARP request prior to forwarding an IP packet. If a reply is not received, the
system repeats the request three times. These packets are counted in encapsulation
failed.
Rcvd: Total number of packets received from specified protocol.
...short packets The number of bytes in the packet are too small.
...bad length The length of the packet was not correct.
...no port
broadcasts
The incoming broadcast/multicast packet did not have any listener.
910 IPv4 Routing