Administrator Guide

ip igmp last-member-query-interval
Change the last member query interval, which is the Max Response Time inserted into Group-Specific Queries sent in response to Leave
Group messages. This interval is also the interval between Group-Specific Query messages.
C9000 Series
Syntax
ip igmp last-member-query-interval milliseconds
To return to the default value, use the no ip igmp last-member-query-interval command.
Parameters
milliseconds Enter the number of milliseconds as the interval. For IGMP version 2, the range is from
100 to 25599. For IGMP version 3, the range is from 100 to 65535. The default value is
1000 milliseconds.
Defaults 1000 milliseconds
Command Modes
INTERFACE
INTERFACE (BATCH Mode)
Command History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.10(0.0) Introduced the Configuration Terminal Batch mode on C9010.
9.9(0.0) Introduced on the C9010.
9.7(0.1) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000-ON. For IGMP version 2, the Interval range is modified.
9.5(0.1) Introduced on the Z9500.
9.2(0.0) Introduced on the M I/O Aggregator. This command is supported in Programmable-Mux
(PMUX) mode only.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
E-Series legacy
command
ip igmp querier-timeout
Change the interval that must pass before a multicast router decides that there is no longer another multicast router that should be the
querier.
C9000 Series
Syntax
ip igmp querier-timeout seconds
To return to the default value, use the no ip igmp querier-timeout command.
838 Internet Group Management Protocol (IGMP)