Administrator Guide

interface vlan — configures a VLAN.
interface ManagementEthernet
Configure the Management port on the system (either the Primary or Standby RPM).
C9000 Series
Syntax
interface ManagementEthernet slot/port
Parameters
slot/port Enter the keyword ManagementEthernet, then the slot number (0 or 1) and port
number zero (0).
Defaults Not configured.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.11.1 Introduced on the S55, S60, and S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.5.1.0 Introduced on the C-Series.
6.4.1.0 Introduced
Usage Information
You cannot delete a Management port.
The Management port is enabled by default (no shutdown). To assign an IP address to the Management port,
use the ip address command.
If your system has two RPMs installed, use the show redundancy command to display which RPM is the
Primary RPM.
Example
Dell(conf)# interface managementethernet 0/0
Dell(conf-if-ma-0/0)#
Related
Commands
management route — configures a static route that points to the Management interface or a forwarding router.
speed (Management interface) — clears the FIB entries on a specified line card.
interface null
Configure a Null interface on the switch.
C9000 Series
Syntax
interface null number
Parameters
number Enter zero (0) as the Null interface number.
Interfaces 693