Administrator Guide

ipv4acl number
Enter ipv4acl and the FP block number for IPv4. The FP block number range is from 0
to 8.
ipv6acl number
Enter ipv6acl and the FP block number for IPv6. The FP block number range is from 0
to 4 (multiples of 2).
ipv4qos number
Enter ipv4qos and the FP block number for IPv4–QoS. The FP block number range is
from 0 to 8.
l2qos number
Enter l2qos and the FP block number for L2–QoS. The FP block number range is from 1
to 8.
l2pt number
Enter l2pt and the FP block number for L2–Protocol tunneling. The FP block number
range is from 0 to 1.
ipmacacl number
Enter ipmacacl and the FP block number for IP-MAC ACL. The FP block number range
is from 0 to 6.
vman-qos number
Enter vman-qos and the FP block number for Vman QoS. The FP block number range is
from 0 to 6.
ecfmacl number
Enter ecfmacl and the FP block number for ECFM ACL. The FP block number range is
from 0 to 5.
fcoeacl number
Enter fcoeacl and the FP block number for FCoE ACL. The FP block number range is 0
to 6.
fedgovacl number
Enter fedgovacl and the FP block number for Fed Gov ACL. The FP block number
range is 0 to .
nlbclusteracl
number
Enter nlbclusteracl and the FP block number for NLB Cluster ACL. The FP block
number range is 0 to 6.
ipv4pbr number
Enter ipv4pbr and the FP block number for IPv4 PBR ACL. The FP block number range
is 0 to 6.
iscsioptacl number
Enter iscsioptacl and the FP block number for ISCSI optimization ACL. The FP block
number range is 0 to 6.
openflow number
Enter openflow and the FP block number for OpenFlow ACL. The FP block number
range is 0 to 6.
vrfv4acl number
Enter vrfv4acl and the FP block number for VRF ACL. The FP block number range is 0
to 6.
Command Modes
CONFIGURATION
CONFIGURATION TERMINAL BATCH
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.10(0.0) Introduced the Configuration Terminal Batch mode on C9010.
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
9.2(0.0) Added support for the fcoe parameter on the S4810 and S4820T.
9.1.(0.0) Added support for OpenFlow on the Z9000.
Control and Monitoring 65