Administrator Guide

Example 2: Output
of the show cam-
usage acl
Command
Dell#show cam-usage acl
Stackunit|Portpipe| CAM Partition | Total CAM | Used CAM |Available
CAM
========|========|=================|=============|=============|============
11 | 0 | IN-L2 ACL | 1008 | 0 |
1008
| | IN-L3 ACL | 12288 | 2 |
12286
| | OUT-L2 ACL | 1024 | 2 |
1022
| | OUT-L3 ACL | 1024 | 0 | 1024
| | IN-L3 ECMP GRP | 1024 | 0 | 1024
Example 3: Output
of the show cam-
usage router
Command
Example 4: Output
of the show cam-
usage switch
Command
show cam-acl-pe
Display details of global ingress CAM ACL profiles for the port extender.
C9000 Series
Syntax
show cam-acl-pe
Defaults None
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
Usage Information
The display reflects the settings implemented with the cam-acl-pecommand.
This command only displays the details of CAM ACL profiles configured globally on the PE. It does not display
CAM ACL profiles for each PE.
Example
Dell# show cam-acl-pe
-- Port extender Cam ACL --
Current Settings(in block sizes)
1 block = 256 entries
L2Acl : 6
Ipv4Acl : 4
Ipv6Acl : 0
Ipv4Qos : 2
L2Qos : 1
IpMacAcl : 0
486 Content Addressable Memory (CAM)