Administrator Guide

ManualsBrandsDell ManualsAccess PlatformsC9010 Modular Chassis Switch

411

412

413

414

415

416

417

418

419

420

Defaults Not configured.

Command Modes CONFIGURATION (conf-ext-community-list)

Command History

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell

Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version Description

9.9(0.0) Introduced on the C9010.

9.2(1.0) Introduced on the Z9500.

7.8.1.0 Introduced on the S-Series.

7.7.1.0 Introduced on the C-Series.

7.6.1.0 Introduced on the E-Series.

Usage Information Duplicate commands are silently accepted.

Example

Dell(conf-ext-community-list)#permit regexp 123

Dell(conf-ext-community-list)#

Commands

deny regex — denies a community using a regular expression.

set extcommunity rt

To set Route Origin community attributes in Route Map, use this feature.

C9000 Series

Syntax

set extcommunity rt {as4 ASN4:NN [non-trans] | ASN:NNNN [non-trans] | IPADDR:NN

[non-trans]} [additive]

To delete the Route Origin community, use the no set extcommunity command.

Parameters

as4

ASN4:NN

Enter the keyword as4 then the 4-octet AS specific extended community number in the

format ASN4:NN (4-byte AS number:2-byte community value).

ASN:NNNN

Enter the 2-octet AS specific extended community number in the format ASN:NNNN (2-

byte AS number:4-byte community value).

IPADDR:NN

Enter the IP address specific extended community in the format IPADDR:NN (4-byte IPv4

Unicast Address:2-byte community value).

additive

(OPTIONAL) Enter the keyword additive to add to the existing extended community.

non-trans (OPTIONAL) Enter the keywords non-trans to indicate a non-transitive BGP extended

community.

Defaults none

Command Modes ROUTE MAP (config-route-map)