Administrator Guide

host ip-address Enter the keyword host then the IP address to specify a host IP address.
destination Enter the IP address of the network or host to which the packets are sent.
log (OPTIONAL) Enter the keyword log to include ACL matches in the log.
dscp Enter this keyword dscp to deny a packet based on the DSCP value. The range is from 0
to 63.
count (OPTIONAL) Enter the keyword count to count packets processed by the filter.
bytes (OPTIONAL) Enter the keyword bytes to count bytes processed by the filter.
order (OPTIONAL) Enter the keyword order to specify the QoS priority for the ACL entry.
The range is from 0 to 254 (where 0 is the highest priority and 254 is the lowest; lower
order numbers have a higher priority) If you did not use the keyword order, the ACLs
have the lowest order by default (255).
monitor (OPTIONAL) Enter the keyword monitor when the rule is describing the traffic that you
want to monitor and the ACL in which you are creating the rule is applied to the
monitored interface. For more information, refer to the “Flow-based Monitoring” section
in the Port Monitoring chapter of the Dell Networking OS Configuration Guide.
fragments Enter the keyword fragments to use ACLs to control packet fragments.
Defaults Not configured.
Command Modes CONFIGURATION-EXTENDED-ACCESS-LIST
Command History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.3.1.0 Added the keyword dscp.
8.2.1.0 Allows ACL control of fragmented packets for IP (Layer 3) ACLs.
8.1.1.0 Introduced on the E-Series ExaScale.
6.5.1.0 Expanded to include the optional QoS order priority for the ACL entry.
Usage Information
Use the order option only when you use policy-based QoS on the switch. For more information, refer to the
Quality of Service chapter of the C9000 Series Configuration Guide.
When you use the log option, the CP processor logs detail the packets that match. Depending on how many
packets match the log entry and at what rate, the CP may become busy as it has to log these packets’ details.
Use the monitor option only when you are using flow-based monitoring. For more information, refer to the Port
Monitoring chapter of the C9000 Series Configuration Guide.
NOTE: When ACL logging and byte counters are configured simultaneously, byte counters may
display an incorrect value. Configure packet counters with logging instead.
ICMP Message
Type Keywords
ICMP Message Type Name
administratively-
prohibited
Administratively prohibited
alternate-address Alternate host address
230 Access Control Lists (ACL)