Administrator Guide

Version Description
9.0(0.0) Added support for IPv6 for the file-url parameter.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000. Added support for the SSD on the Z9000 only.
8.3.7.0 Introduced on the S4810.
7.7.1.0 Added support for TFTP and SCP.
7.6.1.0 Introduced on the S-Series.
Usage Information
A system message displays with status information about the bootflash upgrade.
RFC 3986 specifies that IPv6 host addresses in a uniform resource identifier (URI) must be enclosed in square
brackets, [X:X:X:X::X]. For maximum flexibility, this command accepts IPv6 host addresses with or without the
square brackets.
Reload the system after executing this command.
To upgrade the Dell Networking OS image on a port extender from an attached PE console, enter the upgrade
command in EXEC mode.
In a dual homing setup, you can use this command only from the primary VLT peer.
Examples
(upgrade
bootflash-image
all booted)
Dell#upgrade bootflash-image all booted
Current Boot information in the system:
============================================
Card BootFlash Current Version New Version
---------------------------------------------------------------------
rpm 0 (CP) Boot Flash 3.3.1.15 3.3.1.15
rpm 0 (RP) Boot Flash 3.3.1.15 3.3.1.15
Linecard10 Boot Flash 3.3.1.15 3.3.1.15
***********************************************************************
* Warning - Upgrading boot flash is inherently risky and should only *
* be attempted when necessary. A failure at this upgrade may cause *
* a board RMA. Proceed with caution ! *
***********************************************************************
Proceed Boot Flash image for all cards [yes/no]: no
Example (upgrade
bootselector-
image all booted)
Dell#upgrade bootselector-image all booted
Current Boot information in the system:
===========================================
Card BootSelector Current Version New Version
--------------------------------------------------------------------
rpm 0 (CP) Boot Selector 3.3.0.0c 3.3.0.0f
rpm 0 (RP) Boot Selector 3.3.0.0c 3.3.0.0f
Linecard10 Boot Selector 3.3.0.0c 3.3.0.0f
***********************************************************************
* Warning - Upgrading boot selectors is inherently risky and should *
* only be attempted when necessary. A failure at this upgrade may *
* cause a board RMA. Proceed with caution ! *
***********************************************************************
Proceed Boot Selector image for all cards [yes/no]: no
File Management 187