Administrator Guide

Dell(conf)#snmp-server community guest ro snmp-ro-acl
Dell(conf)#
Related
Commands
ip access-list standard — names (or selects) a standard access list to filter based on IP address.
ipv6 access-list — configures an access list based on IPv6 addresses or protocols.
show running-config — displays the current SNMP configuration and defaults.
snmp-server enable traps
Enable SNMP traps.
C9000 Series
Syntax
snmp-server enable traps [notification-type] [notification-option]
To disable traps, use the no snmp-server enable traps [notification-type] [notification-
option] command.
Parameters
notification-type Enter the type of notification from the following list:
• bgp — Enable notification of changes in the BGP process.
• config — Enable notification of changes to startup or running configuration.
• dot1br— Enable notification of changes to DOT1BR.
• ecfm — Enable notification of changes to ECFM.
• ecmp — Enable notification of traffic imbalance in ECMP or a link bundle.
• entity —Enable notification of Entity Management Information Base (MIB)
changes.
• envmon — Enable notification when an environmental threshold is exceeded.
• ets — Enable notification of ETS changes.
• fips — Enable notification of a FIP Snooping state changes.
• hg-lbm — Enable notification of hiGig link-bundle state changes.
• isis — Enable notification of IS-IS adjacency state changes.
• pfc — Enable notification of changes to PFC.
• lacp — Enable notification of LACP state changes.
• snmp — Enable SNMP notifications defined in RFC 1157.
• stp — Enable notification of a state change in the spanning tree protocol (RFC
1493).
• vlt — Enable notification of VLT state changes.
• vrrp —Enable notification of a state change in a VRRP group.
• xstp — Enable notification of a state change in MSTP (802.1s), RSTP (802.1w), and
PVST+.
notification-option
For the envmon notification-type, enter one of the following optional parameters:
• cam-utilization
• fan
• supply
• temperature
For the snmp notification-type, enter one of the following optional parameters:
• authentication
• coldstart
• linkdown
• linkup
Defaults Not enabled.
1554 Simple Network Management Protocol (SNMP) and Syslog