Administrator Guide

ManualsBrandsDell ManualsAccess PlatformsC9010 Modular Chassis Switch

1421

To return to the default, use the no ip rip receive version command.

Parameters

1 (OPTIONAL) Enter the number 1 for RIP version 1.

2 (OPTIONAL) Enter the number 2 for RIP version 2.

Defaults RIPv1 and RIPv2

Command Modes INTERFACE

Command History

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell

Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version Description

9.9(0.0) Introduced on the C9010.

9.2(1.0) Introduced on the Z9500.

8.3.19.0 Introduced on the S4820T.

8.3.11.1 Introduced on the Z9000.

8.3.7.0 Introduced on the S4810.

7.8.1.0 Introduced on the S-Series.

7.6.1.0 Introduced on the C-Series.

6.2.1.1 Introduced on the E-Series.

Usage Information If you want the interface to receive both versions of RIP, use the ip rip receive version 1 2 command.

Commands

ip rip send version — sets the RIP version for sending RIP traffic on an interface.

version — sets the RIP version the switch software uses.

ip rip send version

To send a specific version of RIP, set the interface. The version you set on the interface overrides the version command in ROUTER RIP

mode.

C9000 Series

Syntax

ip rip send version [1] [2]

To return to the default value, use the no ip rip send version command.