Administrator Guide

match ip access-group
Configure match criteria for a class map, based on the access control list (ACL).
C9000 Series
Syntax
match ip access-group access-group-name [set-ip-dscp value]
To remove ACL match criteria from a class map, use the no match ip access-group access-group-
name [set-ip-dscp value] command.
Parameters
access-group-
name
Enter the ACL name whose contents are used as the match criteria in determining if
packets belong to the class the class-map specifies.
set-ip-dscp value (OPTIONAL) Enter the keywords set-ip-dscp then the IP DSCP value. The matched
traffic is marked with the DSCP value. The range is from 0 to 63.
Defaults none
Command Modes CLASS-MAP CONFIGURATION (config-class-map)
Command History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.7.1.0 Added the DSCP Marking option support on the S-Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
7.5.1.0 Added support for the DSCP Marking option.
6.1.1.1 Introduced on the E-Series.
Usage Information To access this command, enter the class-map command. After the class map is identified, you can configure
the match criteria. For class-map match-any, a maximum of five ACL match criteria are allowed. For class-map
match-all, only one ACL match criteria is allowed.
Related
Commands
class-map — identifies the class map.
match ip dscp
Use a differentiated services code point (DSCP) value as a match criteria.
C9000 Series
Syntax
match {ip | ipv6 | ip-any} dscp dscp-list [set-ip-dscp value | set-color value]
To remove a DSCP value as a match criteria, use the no match {ip | ipv6 | ip-any} dscp dscp-
list [[multicast] set-ip-dscp value | set-color value] command.
1364 Quality of Service (QoS)