Users Guide

Maximum number of connections is 256
------------------------------------------------
iSCSI Targets and TCP Ports:
------------------------------------------------
TCP Port Target IP Address
3260
860
The following example shows the show iscsi session command.
VLT PEER1
Dell#show iscsi session
Session 0:
----------------------------------------------------------------------------
Target: iqn.2001-05.com.equallogic:0-8a0906-0e70c2002-10a0018426a48c94-iom010 Initiator:
iqn.1991-05.com.microsoft:win-x9l8v27yajg
ISID: 400001370000
VLT PEER2
Session 0:
-----------------------------------------------------------------------------
Target: iqn.2001-05.com.equallogic:0-8a0906-0f60c2002-0360018428d48c94-iom011
iqn.1991-05.com.microsoft:win-x9l8v27yajg
ISID: 400001370000
The following example shows the show iscsi session detailed command.
VLT PEER1
Dell# show iscsi session detailed
Session 0:
--------------------------------------------------------
Target:iqn.2010-11.com.ixia:ixload:iscsi-TG1
Initiator:iqn.2010-11.com.ixia.ixload:initiator-iscsi-2c
Up Time:00:00:01:28(DD:HH:MM:SS)
Time for aging out:00:00:09:34(DD:HH:MM:SS)
ISID:806978696102
Initiator Initiator Target Target Connection
IP Address TCP Port IP Address TCPPort ID
10.10.0.44 33345 10.10.0.101 3260 0
VLT PEER2
Session 0:
--------------------------------------------------------
Target:iqn.2010-11.com.ixia:ixload:iscsi-TG1
Initiator:iqn.2010-11.com.ixia.ixload:initiator-iscsi-2c
Up Time:00:00:01:28(DD:HH:MM:SS)
Time for aging out:00:00:09:34(DD:HH:MM:SS)
ISID:806978696102
Initiator Initiator Target Target Connection
IP Address TCP Port IP Address TCPPort ID
10.10.0.53 33432 10.10.0.101 3260 0
Enable and Disable iSCSI Optimization
The following describes enabling and disabling iSCSI optimizaiton.
NOTE: iSCSI monitoring, auto-configuration and auto-detection is enabled by default.
If you enable iSCSI, flow control is automatically enabled on all interfaces. To disable flow control on all interfaces, use the no
flow control rx on tx off command and save the configuration. To disable iSCSI optimization, which can turn on flow
control again on reboot, use the
no iscsi enable command and save the configuration.
When you enable iSCSI on the switch, the following actions occur:
• Link-level flow control is enabled on interfaces where PFC is disabled.
iSCSI Optimization 514