Users Guide

psuFanSpeedTest (0, 1)
psuFanStatusTest (0, 1)
psuPresenceTest (0, 1)
psuShowTempTest (0, 1)
psuStatusTest (0, 1)
psuVoltageTest (0, 1)
usbTest (0, 1)
fanCntrlSpeedTest (1, 1)
i2cTest (1, 1)
psuEepromAccessTest (1, 1)
udfLinkStatusTest (1, 1)
usbTest (1, 1)
ipcPingTrafficTest (2, 1)
.
The following example shows the show diag linecard detail command.
ell#show diag linecard 4 detail
Diag status of linecard member 4:
--------------------------------------------------------------------------
Board: C9010 Dell Networking
=================================================
linecard is currently offline.
linecard alllevels diag issued at Sun Apr 26, 2015 10:32:01 PM.
Current diag status : Card diags are done.
Duration of execution (Total) : 1 min 13 sec.
Diagnostic test results located: flash:/TestReport-LP-4.txt
Last notification received at Sun Apr 26, 2015 10:33:14 PM
--------------------------------------------------------------------------
Called with cpu = 3 slotID = 4
DELL DIAGNOSTICS-C9000-CP00 [0]
CpuType -- LM
PPID -- CN0CYFF2779314A60021
PPID Rev -- X00
Service Tag -- 15YQG02
Part Number -- 0CYFF2
Part Number Revision -- X00
LM CPLD -- 31
LM extended CPLD -- 30
SW Version -- 1-0(0-4854)
Available free memory: 1,664,086,016 bytes
LEVEL 0 DIAGNOSTIC
Starting test: bcm56854AccessTest ......
+ Access Test for unit 0 : PASSED
bcm56854AccessTest .......................................... PASS
biosVerGetTest .............................................. PASS
boardRevisionTest ........................................... PASS
cpldAccessTest .............................................. PASS
Starting test: CpuGbeLinkStatusTest ......
+ GbE1 Link Status UP
+ GbE2 Link Status DOWN
CpuGbeLinkStatusTest ........................................ FAIL
cpuRevisionTest ............................................. PASS
cpuSdramPresenceTest ........................................ PASS
cpuSdramSizeTest ............................................ PASS
eepromTest .................................................. PASS
extenderCpldAccessTest ...................................... PASS
Starting test: hgLinkStatusTest ......
ERROR: Unit 0 hg port 30 is DOWN
Debugging and Diagnostics 303