Users Guide

The following table describes the show interface ets detail command fields.
Table 21. show interface ets detail Command Description
Field Description
Interface Interface type with stack-unit, linecard, and port number. The
port type can be ten gigabit or forty gigabit.
Maximum Supported TC Maximum number of priority groups supported.
Number of Traffic Classes Number of 802.1p priorities currently configured.
Admin mode ETS mode: on or off.
Admin Parameters ETS configuration on local port, including priority groups,
assigned dot1p priorities, and bandwidth allocation.
Remote Parameters ETS configuration on remote peer port, including Admin
mode (enabled if a valid TLV was received or disabled), priority
groups, assigned dot1p priorities, and bandwidth allocation. If
the ETS Admin mode is enabled on the remote port for DCBx
exchange, the Willing bit received in ETS TLVs from the
remote peer is included.
Local Parameters ETS configuration on local port, including Admin mode
(enabled when a valid TLV is received from a peer), priority
groups, assigned dot1p priorities, and bandwidth allocation.
Operational status (local port) Port state for current operational ETS configuration:
• Init: Local ETS configuration parameters were exchanged
with peer.
• Recommend: Remote ETS configuration parameters were
received from peer.
• Internally propagated: ETS configuration parameters were
received from configuration source.
ETS DCBx Oper status Operational status of ETS configuration on local port: match
or mismatch.
State Machine Type Type of state machine used for DCBx exchanges of ETS
parameters:
• Feature: for legacy DCBx versions
• Asymmetric: for an IEEE version
Conf TLV Tx Status Status of ETS Configuration TLV advertisements: enabled or
disabled.
ETS TLV Statistic: Input Conf TLV pkts Number of ETS Configuration TLVs received.
ETS TLV Statistic: Output Conf TLV pkts Number of ETS Configuration TLVs transmitted.
ETS TLV Statistic: Error Conf TLV pkts Number of ETS Error Configuration TLVs received.
The following example shows the show linecard 2 port-set 0 backplane all pfc details command.
Dell#show linecard 2 port-set 0 backplane all pfc details
2 port-set 0 backplane all
Admin mode is On
Admin is enabled, Priority list is 3
Local is enabled, Priority list is 3
Link Delay 65535 pause quantum
0 Pause Tx pkts, 0 Pause Rx pkts
Data Center Bridging (DCB) 276