Administrator Guide

ManualsBrandsDell ManualsAccess PlatformsC9010 Modular Chassis Switch

761

762

763

764

765

766

767

768

769

770

• Set the RIP versions sent out on that interface.

INTERFACE mode

ip rip send version [1] [2]

To see whether the version command is configured, use the show config command in ROUTER RIP mode. To view the routing

protocols configuration, use the show ip protocols command in EXEC mode.

The following example shows the RIP configuration after the ROUTER RIP mode version command is set to RIPv2. When you set

the ROUTER RIP mode version command, the interface (TengigabitEthernet 0/0) participating in the RIP process is also set to send

and receive RIPv2 (shown in bold).

Dell#show ip protocols

Routing Protocols is RIP

Sending updates every 30 seconds, next due in 23

Invalid after 180 seconds, hold down 180, flushed after 240

Output delay 8 milliseconds between packets

Automatic network summarization is in effect

Outgoing filter for all interfaces is

Incoming filter for all interfaces is

Default redistribution metric is 1

Default version control: receive version 2, send version 2

Interface Recv Send

TengigabitEthernet 0/0 2 2

Routing for Networks:

10.0.0.0

Routing Information Sources:

Gateway Distance Last Update

Distance: (default is 120)

Dell#

To configure an interface to receive or send both versions of RIP, include 1 and 2 in the command syntax. The command syntax for

sending both RIPv1 and RIPv2 and receiving only RIPv2 is shown in the following example.

Dell(conf-if)#ip rip send version 1 2

Dell(conf-if)#ip rip receive version 2

The following example of the show ip protocols command confirms that both versions are sent out on the interface. This interface

no longer sends and receives the same RIP versions as the system does globally (shown in bold).